Firestik SS-JBS4A



	Orders with radio work are delayed 7 - 14 days

SS-JBS4A
JEEP BUMP STOP ANTENNA MOUNT

Also Available in Mini-Kit

This stainless steel mount bolts to the left or right side of the spare tire bump stop on pre-1997 Jeeps that have the bump stop option. Stainless steel mounting hardware is included. Mounting requires you to drill four 1/4"(7mm)holes in the side of the bump stop bracket. To achieve adequate roof clearance and realize sufficient RF radiation with minimal reflection, especially on vehicles with either a hard or soft top, the minimum antenna length used on bump stop installations should be 4' (1.2m).

The mount comes complete with our heavy-duty SO-239 antenna stud. The actual mounting surface is approximately 1 5/8" (43mm) square. Outward protrusion is about 2 1/2" (64mm). The mounting hole pattern, center to center, is based upon a 1" (25mm) square. Base material thickness is 0.100" (2.5mm).

Discontinued

Try THIS BRACKET (the SS-64A) in the same location for an even stronger hold especially for longer antennas.

"Like many other Firestik mounts, the versatility of these mounts go well beyond their targeted use. When you hold this mount in your hand you will start to recognize all of the mounting possibilities".

Firestik also manufactures a mount and coaxial cable Mini-kit for bump stop installations. The mini-kit features the low-profile Firestik exclusive FireRing terminated coaxial cable.

		TECH INFO