| The 
        Road-King 56 (RK-56) Dynamic Microphone is designed for voice 
        communications applications requiring a rugged, hand-held microphone. 
        Its noise-canceling design makes it particularly effective for use in 
        noisy locations, and its excellent voice response characteristics make 
        it a good choice in quiet areas as well.      The RK-56 uses dynamic, differential type 
        cartridge which discriminates against sounds greater than ½-inch (12 mm) 
        away. A non-marking lip guard assures the user of correct 
        microphone-to-mouth positioning. Best noise cancellation is achieved 
        with the edge of the lip guard just touching the upper lip. The push-to 
        talk switch is located on the top of the microphone housing. The RK-56 
        is equipped with the  Highest Quality, "BELDEN" six-conductor, 
        receive coiled cord which is relieved at the microphone housing by a 
        telephone type strain relief grommet. The cord may be wired for either 
        relay or electronic switching. 
          Dynamic LO-Z Noise canceling microphoneNon-AmplifiedPolyurethane coated steel grill screenLimited one year warrantyPre-wired for 4 pin Cobra, REQUIRES PLUG and WIRING 
			for other types of radios.
   
            
              | Specifications: 
  Microphone type:  Noise-canceling dynamicFrequency response: 100 Hz to 8 KHzOutput level at 1 KHz:Open circuit: -72 db (ref: 0 db= 1 V/ubar)
 Power level: -55db  (ref: 0 db= 1 mW/10 ubar)
Output Impedance: 2000 ohms (matches 600-5000
    ohm inputs)Cable (mic cord):6 conductor, receive, coiled cord: 12 inches (304 mm)
 retracted and 6 feet (1.8m) extended.
CASE: receive CycolacWeight:8 ounces (0.2 kg)UPC #: 0 45464 76964 3Manufacturer - DAS Distributors (NOT Turner and NOT Telex)     
					
					
					IMPORTANT NOTE:PLEASE READ THIS 
					!!!!
 
					
						| 
						
						This is a 
						
						noise canceling microphone:Don't forget the lip guard is there to remind you of the 
						
						
						
						
						close spacing required. To best describe the spacing,I would say your upper lip touches the rubber guard 
						and bottom lip should almost drag the screen when 
						talking. Take this mic away even 1" or tilt sideways from your mouth and 70% of your audio 
						is GONE !!!
  |    See this video on how to properly hold this NOISE canceling 
				  mic.
 
				           |  |